Basement Systems of New York Before & After Photos

This is an example of a before and during picture. Our team had to jackahmmer around the entire floor and even underneath and around obstacles such as water heaters. After jackhammering our team removes the cement and dirt which lies underneath the floor. After removing all of that they then, add crushed blue stone to help direct the water that seeps in through the wall and floor causing dampness, moisture, and mold. After that they installed our patented WaterGuard system, which also collects water and directs the water to the Triple Safe Sump Pump. This is what removes the water from the house. Our team sets up two Sump pumps inside of the basin which is perferated to allow the flow of water into the basin. The Sump pumps then are connected to the plumping that we also install that led to outside. Once outside our team digs another trench and installs a dischage system to remove the water further away from the house. 

This basement had a problem will dampness due to wall and floor water seepage. In order to get this basement dry our team did the following. First to start this job our team set up a plastic barrier to protect the homeowners belongings from the dust created by jackhammering and mixing cement. After jackhammmering and removing any debris from the basement, in this case it was put in buckets then pushed out a window, then hauled away in dumptrucks. Our team insatalled WaterGuard and and crushed blue stone to hold the water and direct it to the Triple Safe Sump Pump. This removes the water out of the basement and takes it outside into a discharge line where it is taken away from the house to eliminate future problems with water entering the basement. 

These before and after pictures show the transformation of this nasty dirty crawlspace into something much better. This crawlspace has our patented CleanSpace vapor barrier installed to eliminate moisture from soaking into the floor joists and creating rot in the floor. 

25 years ago we installed our patented CleanSpace throughout the entirety of this home's crawl space. Now 25 years later they called us back to take care of their foundation and humidity issues that they were having.

The main issue that they had called us about originally was for their foundation and humidity issues, but to fix the problems at hand we had to remove a majority of the work we had done 25 years ago and replace it to remove the old supports, and install our new support systems. In doing so all of the issues they were having would be alleviated and would make this home like new.

For us to take care of the foundation issues we started by supporting the home to pull out and replace all of their block supports throughout the entire crawl space, we then strategically installed a total of 30 SmartJacks throughout the crawl space, all of which would tie directly into the main girder and our newly installed steel i-beam. We then removed their old inefficient sump pump system and installed our SmartSump with a 35-foot discharge line.

After installing our sump pump system we then installed our drain matting underneath our new CleanSpace. Because in the back section of the crawl space we did not need to remove and replace our old CleanSpace we only laid it throughout the main section and the right section of their crawl space past the chimney. Once this was completed we installed our Everlast door in their existing basement entryway so they could have full access to check on things, as well as store any belongings that they would like to in their new space.

Finally, before completing our project, we installed our patented BasementAire Dehumidification system, this system will help to keep the humidity in their crawl space and home as low as possible due to its proprietary hourly air sampling system. Overall the homeowner could not have been more ecstatic about the outcome, but more importantly to them that they were able to regain peace of mind and did not have to worry every night when they went to sleep if their home was going to fall over.

This homeowner contacted Basement Systems of New York because their home had a cinder block post-and-beam foundation with a dirt-floor crawlspace. Upon their yearly inspection of the space, they discovered a hole over ten inches in the cinder block above the frost line. Their main priority was to address the foundation issues that they were currently dealing with, as well they wanted to clean up and encapsulate their crawl space.

To take care of all the issues plaguing their crawl space, we first removed all the old fiberglass from the crawl space ceiling. Next, we started to dig our basin hole for our SuperSump plus sump pump system with a discharge line out to daylight, which we then tied into our SmartPipe waterproofing system. Once this was completed we started to excavate and remove their deteriorated support system, which we then replaced with ten SmartJack support systems. 

Finally, we sprayed 3" of closed-cell spray foam on their rim joists, installed our Basementaire dehumidification system, and encapsulated the entirety of their crawl space with our patented 20 mil CleanSpace encapsulation system with drain mat underneath it. By doing this we can keep any water from seeping into their crawl space, as well as use the path of least resistance to direct any water to our SmartPipe waterproofing system and directly out of their home through our patented SuperSump plus sump pump system. 

After installing our patented systems these homeowners noticed immediately that the structural integrity of their home vastly increased, as well that their home was much more comfortable thanks to all of the systems that we implemented in their crawl space. These homeowners could not have been any more pleased with how their project turned out. More importantly to them, than anything was that they had peace of mind restored back to them.